composite sample

Determination of Complete Pole Figure of Metal Sheet by Composite Sample

用组合试样测建板材的完整极图

Study of Dynamic Characteristic Test of Clay-Sand Layered Composite Sample

砂土&粘土分层复合试样动力特性试验研究

The maximum dynamic modulus of composite sample is much higher than that of pure clay but the damping ratio is lower .

经过置换后，复合试样的最大动模量比纯黏土的最大动模量提高，而阻尼比减小；

A systematic review and discussion on the method for determining a complete pole figure of metal sheet by the use of a composite sample were made .

本文根据X射线实验室织构分析工作的需要，对用组合试样测建完整极图的方法进行了系统地综述和讨论。

The studies of hydrogen behaviour in HR-1 stainless steel and its composite sample with CVD coated chromium oxidic film have been presented .

本文介绍氢在HR－1不锈钢基体及镀有氧化铬膜的复合材料中的行为研究，包括基体的准备；膜的制备；

Steady state permeation experiments of hydrogen in stainless steel and its composite sample with coated chromium oxidic film the oxidative resistance of Cr-carbides

氢在不锈钢及氧化铬膜复合体中的稳态渗透实验含铬碳化物的氧化稳定性

X-ray photoelectron spectra ( XPS ) analysis the value states of Ag and Cu in the implanted composite sample , the results show that Ag and Cu exist in the form of metal state .

用X射线光电子能谱（XPS）分析注入样品的价态分布，发现Ag、Cu仍以金属态形式存在。

Many test results showed that both lateral or vertical deformation modulus and strength of the composite sample can not be obtained by adding that of reinforcing pile and soil together simply in accordance with the geometric proportion .

大量的试验结果表明：无论是在水平方向还是纵向，复合体的变形模量和强度都不是两种材料按一定几何比例的简单叠加；

Compared with MoSi_2 sample , the crystal grain of LaNbO_4-MoSi_2 composite sample was obviously fine , and the compactness was increased . Microhardness , bend strength and fracture toughness were greatly improved as well .

LaNbO4-MoSi2复合试样与单相MoSi2相比，其晶粒明显细化，致密性提高，强度、硬度和断裂韧性均有较大提高。

Using metal-coated casting technique , gradient composite sample was produced on the surface of vermicular graphite cast iron , which was carried out oxidation test in air at high temperature of 900 ℃ for 103 h increasing weight .

采用金属涂覆铸造技术，在铁基表面制备梯度复合材料层，对试样进行了900℃、103h高温氧化增重实验；

Based on a series of triaxial compression tests , the writers get the Duncan Chang model parameters of the composite sample , the mixed sample , the curve added method , the parameter added method and the layered sample .

在常规三轴试验的基础上得出了用复合试样、混和试样、曲线叠加、数值试验、参数叠加和分层试样确定的堤坝复合地基的DuncanChang模型参数，并用这些参数进行了有限元计算。

However , if the parent distribution deviates greatly from the Gaussian distribution ( or t distribution ) and the composite sample contains a small number of increments , bootstrap method gives more reasonable confidence intervals than parametric method .

但对偏离正态分布（或t-分布）的总体且组合样中的份样数目较少时，非参数法较参数法的结果更符合实际。

Pores and density along the radial direction of the composite sample deposited at different temperatures were measured by means of Leica quantitative metallography and Archimedes principle methods . Morphologies and pores of the composites were observed by scanning electron microscopy .

用Leica定量金相分析仪及Archimedes排水法测定了不同沉积温度制备的样品沿径向的孔隙率及密度分布，同时用扫描电子显微镜观察了样品的低倍形貌及孔隙率分布。

In addition , experiment on composite triaxial sample composed of gangue cylinder core strengthen and clay shell and gangue concrete strengthen are also completed .

完成了由煤矸石碴圆柱芯增强体和粘性土外筒组成的复合三轴试样的试验以及煤矸石混凝土增强体的三轴剪切试验。

Deposit-dip-spin ( DDS ) coating method , a composite nano-powder sample preparation method for atomic force microscope ( AFM ) measurement is introduced .

介绍了一种改进旋涂法&DDS涂膜法（Deposit-Dip-Spin-coating），主要用来制备纳米粉体原子力显微镜（AFM）分析样品。

To investigate its catalytic characteristics , 5 % nano-nickel powder was added into superfine ammonium perchlorate ( AP ), and the composite state of sample was analyzed by means of SEM , XPS .

为了研究纳米Ni粉的催化活性，把质量含量为5%的纳米Ni粉加入到超细粒度AP中，并用SEM、XPS分析复合状态。

We first examine the benefits and challenges of composite applications using the sample scenarios that we developed for illustration .

我们将首先通过这些示例场景来说明组合应用程序的好处和挑战。

The main results of the research include : 1 , The academic results ( 1 ) By the statistical analysis of the samples , it is concluded that all the composite samples and single sample obey the logarithm normal distribution .

理论成果（1）通过样品的统计分析，得出组合样与单样都服从对数正态分布。

In this basis , this article determines the common factors at all levels , the use of ingredients obtained eigenvalue matrix , and then by calculating the weight of different common factors , ultimately calculate the composite score for the sample cities and get ranked .

本文正是在此基础之上，确定各个层次的公因子，利用成分矩阵求得特征值，再通过计算不同公因子的权重，最终计算出各样本城市的综合得分并得到排名。